4 Replacement Procedures 4.11 Power switch board
4-38 [CONFIDENTIAL] QOSMIO G50 Maintenance Manual (960-683)
Installing the Power switch board
The following describes the procedure for installing the power switch board (See Figure 4-
23).
1. Connect the power switch cable to the connector on the power switch board.
2. Arrange the power switch cable under the guides of the cover assembly.
3. Set the power switch board under the guide of the cover assembly and secure it with
the following screw.
• M2.5×4B FLAT HEAD screw ×1
Downloaded from LpManual.com Manuals
To Next Page
Loading...
