2 Troubleshooting Procedures
2-68 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)
5. After displaying [Capture Fingerprint], scan the fingerprint of your right index finger on
the finger sensor. When it successes the number at the center of display of display changes
to “2”, then scan again. When it successes the number changes to “3”, again scan (total
three times).
6. After displaying [Verify Fingerprint], scan the fingerprint of your right index finger on the
finger sensor again. The message of “Verification Successful” is displayed. Click [Next]
button.
7. When [Omnipass Enrollment Wizard] is displayed, you are asked if you want to register
one more finger. Click [No].
To Next Page
Loading...
