Toshiba Tecra S3 - Hinge

4.27 Hinge
Removing the Hinge
To remove the hinge, follow the steps below and refer to Figure 4-51 to 4-53.
1. Remove the following screws and separate the display cover and middle frame.
• M2×4B BIND screw ×4
• M2.5×6S Tapping screw ×2
M2×4B BIND
Display cover
M2×4B BIND
M2×4B BIND
M2×4B BIND
M2.5×6S Tapping
M2.5×6S Tapping
Middle frame
Figure 4-51 separating the display cover and middle frame
4-68 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)