2. Remove the following screw and SPG GND VGA fin.
• M2×3S S-FLAT HEAD screw ×1
3. Remove the following screws and take out the right hinge from the hole of the
middle frame by moving it to the left.
• M2.5×6S Tapping screw ×2
Hinge (right)
SPG GND VGA fin
M2.5×6S Tapping
M2.5×6S Tapping
M2×3S S-FLAT HEAD
Figure 4-52 Removing the hinge (right)
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-69
To Next Page
Loading...
