4.11 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to Figure 4-16.
1. Disconnect the Bluetooth antenna cable from the connector on the Bluetooth
module.
2. Disconnect the Bluetooth cable from the connector CN4400 on the system board.
3. Remove the Bluetooth module from the slot and disconnect the Bluetooth cable
from the connector on the Bluetooth module.
Bluetooth cable
Bluetooth module
Bluetooth antenna cable
CN4400
Figure 4-16 Removing the Bluetooth module
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-27
To Next Page
Loading...
