4.17 Internal microphone
Removing the Internal microphone
To remove the internal microphone, follow the steps below and refer to Figure 4-26.
1. Remove the following screws and front panel.
• M2.5×6S Tapping screw ×2
2. Disconnect the microphone cable from the connector CN6050 on the system board.
3. Take out the internal microphone from the slot of the front panel.
M2.5×6S Tapping
Front panel
CN6050
Microphone
Microphone cable
M2.5×6S Tapping
Figure4-26 Removing the internal microphone
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-41
To Next Page
Loading...
