4 Replacement Procedures
4.24 LCD unit/FL inverter
Removing the LCD unit/FL inverter
To remove the LCD unit/FL inverter, follow the steps below and refer to Figure 4-41 to
4-47.
1. Peel off two mask rubbers and two mask seals and remove the following screws
securing the display mask.
• M2.5×4B FLAT HEAD screw ×2
• M2×4B S-FLAT HEAD screw ×2
2. Remove the display mask while releasing the latches.
M2.5×4B FLAT HEAD
M2.5×4B FLAT HEAD
Mask seal
Mask seal
Mask rubber
M2×4B S-FLAT HEAD
Display mask
Figure 4-41 Removing the display mask
4-58 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)
To Next Page
Loading...
