3. Peel off one insulator from the FL inverter and take out the other one under the
LCD unit.
4. Remove the following screw securing the FL inverter.
• M2×4B S-FLAT HEAD screw ×1
5. Disconnect two cables from the FL inverter and remove the FL inverter from the
slot.
Insulator
M2×4B S-FLAT HEAD
FL inverter
Insulator
Cable
Cable
Figure 4-42 Removing the FL inverter
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-59
To Next Page
Loading...
