4.19 Fan
Removing the Fan
To remove the fan, follow the steps below and refer to Figure 4-29.
1. Peel off the glass tape.
2. Disconnect the fan cable from the connector CN8770 on the system board.
3. Remove the following screws and fan.
• M2.5×4B FLAT HEAD screw ×2
CN8770
Glass Ta
e
M2.5×4B FLAT HEAD
M2.5×4B FLAT HEAD
Fan
Fan cable
Figure 4-29 Removing the fan
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-45
To Next Page
Loading...
