4.6 HDD
CAUTION: When handling the HDD, do not press the top surface as shown by the arrow.
Hold it by the sides.
Removing the HDD
To remove the HDD, follow the steps below and refer to Figure 4-5 and 4-6.
1. Loosen the screw (with e-ring) fixing the HDD cover and slide your finger under the
HDD cover and lift it up to remove.
2. Hold the tub to raise the HDD assembly straight and pull out the HDD assembly
from the connector of the HDD cable.
Screw (with e-ring)
HDD cover
HDD assembly
HDD cable
Figure 4-5 Removing the HDD assembly
4-14 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)
To Next Page
Loading...
