NOTE: The following steps describe how to disassemble the HDD assembly; however, do
not disassemble if the HDD is working properly.
3. Place the HDD assembly on a flat surface, and remove the following screws.
• M3×4S FLAT HEAD screw ×4
4. Separate the HDD and the HDD bracket.
CAUTION: Do not apply pressure to the top or bottom of the HDD.
HDD
HDD bracket
M3×4S FLAT HEAD
M3×4S FLAT HEAD
Figure 4-6 Separating the HDD
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-15
To Next Page
Loading...
