Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-5 and 4-6.
CAUTION: Do not hold the HDD by its top and bottom flat surfaces. It may damage the
HDD.
1. Seat the HDD in the HDD bracket and secure them with the following screws.
• M3×4S FLAT HEAD screw ×4
CAUTION: Do not apply pressure to the middle of the HDD pack. It may damage the
HDD assembly. Hold the HDD assembly by its corners.
2. Set the connector of the HDD cable upward and connect the HDD assembly to the
connector. Press to ensure a firm connection.
3. Set the HDD assembly into the slot.
4. Seat the HDD cover and secure it with the screw (with e-ring).
4-16 [CONFIDENTIAL] TECRA S3 Maintenance Manual (960-532)
To Next Page
Loading...
