Toshiba Tecra S3 - Check of the RAID Configuration; Explanation of the Screen Display

Tests and Diagnostics
3.3 Check of the RAID configuration
Following screen is displayed for checking the RAID configuration and specifying a failed
drive.
TOSHIBA RAID / RAID Information Display Rev xx.xx.xxxx
Copyright(c) 2005 TOSHIBA CORPORATION. All Rights Reserved.
Level Status Capacity
LD0 RAID-1 DEGRADE xxGB
Write cache : Enable
MBR Protection : Disable
S.M.A.R.T : Enable
Port Assgn Status Size Model Rev
0 LD0-0 ONLINE xxGB FUJITSU-------------- xxxxxxx
1 LD0-1 FAILED xxGB FUJITSU-------------- xxxxxxx
< RAID : not OPTIMAL >
3.3.1 Explanation of the screen display
Contents of the screen display are shown below.
Level Status Capacity
LD0 RAID-1 DEGRADE xxGB
Write cache : Enable
MBR Protection : Disable
S.M.A.R.T : Enable
Port Assgn Status Size Model Rev
0 LD0-0 ONLINE xxGB FUJITSU-------------- xxxxxxx
1 LD0-1 FAILED xxGB FUJITSU-------------- xxxxxxx
< RAID : not OPTIMAL >
Physical Drive
information
Logical Drive
information
RAID level
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 3-9