4.16 USB board
Removing the USB board
To remove the USB board, follow the steps below and refer to Figure 4-25.
1. Remove the following screw and lift up the USB board to the left above.
• M2.5×6S Tapping screw ×1
2. Disconnect the USB cable from the connector CN4622 on the USB board.
3. Disconnect the USB cable from the connector CN4610 on the system board and take
it out.
USB cable
M2.5×6S Tapping
CN4622
CN4610
USB board
Figure 4-25 Removing the USB board
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-39
To Next Page
Loading...
