Toshiba Tecra S3 - Modem Daughter Card (MDC)

4.15 Modem Daughter Card (MDC)
Removing the Modem Daughter Card
To remove the modem daughter card, follow the steps below and refer to Figure 4-22 and 4-
23.
1. Remove the following screws securing the modem daughter card.
• M2×4B BIND screw ×2
2. Lift up the modem daughter card to disconnect it from the connector CN3010 on
the system board.
3. Disconnect the modem cable from the connector on the modem daughter card.
Modem daughter card
CN3010
M2×4B BIND
Modem cable
M2
×
4B BIND
Figure 4-22 Removing the Modem Daughter Card (MDC)
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-36