TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-34
Installing the Display assembly
To install the display assembly, follow the steps below and refer to Figure 4-18 to 4-20.
1. Place the display assembly to the base assembly while engaging the latches.
2. Secure the display assembly (front) with the following screws.
• M2.5×8B FLAT HEAD screw ×1
• M2×6S BIND screw ×1
3. Turn up the black tape and connect the LCD cable to the connector CN5500 on the
system board.
4. Connect the speaker cable to the connector CN6170 on the system board.
5. Connect the finger print sensor cable to the connector CN9700 on the system board
and stick the insulator.
6. Close the display and turn the computer face down. Secure the following screws.
• M2.5×16B FLAT HEAD screw ×8 (“16” in the figure 4-19)
• M2.5×8B FLAT HEAD screw ×7 (“8” in the figure 4-19)
• M2.5×4B FLAT HEAD screw ×1 (“4” in the figure 4-19)
To Next Page
Loading...
