12. Peel off two insulators (front of the middle assembly).
13. Remove the following screw and LCD cable holder A.
• M2.5×4S Tapping screw ×1
14. Remove the following screw and LCD cable holder B.
• M2.5×6S Tapping screw ×1
15. Take out the LCD cable from the hole of the middle assembly.
LCD cable holder A
Insulator
LCD cable holder B
LCD cable
M2.5×6S Tapping
M2.5×4S Tapping
Figure 4-47 Removing the LCD cable holder
TECRA S3 Maintenance Manual (960-532) [CONFIDENTIAL] 4-63
To Next Page
Loading...
