Appendices Appendix J Maintenance of TOSHIBA RAID
3. When [Rebuild Range] menu is displayed, the range to be rebuilt is designated.
When [Effective] is selected, rebuild limit becomes valid and it rebuilds up to the
rebuild limit. When [Whole] is selected, it rebuilds maximum capacity of array.
The [Rebuild Range] menu is not displayed when the rebuild limit is not set or the
rebuild limit is the same as the maximum capacity of array. Normally designation
of [Effective] is adequate.
4. Put the cursor on “OK” in [Confirmation] and press Enter key. The rebuild starts.
CAUTION: When the rebuild starts, the data of drive rebuilt is lost.
5. During rebuilding, [Status] of [Physical Drive] becomes “Rebuilding” and the
progress rate, expected remaining time and the number of errors are displayed.
During rebuilding, the [Rebuilding] dialog to select [Suspend] or [Abort] is
displayed. It may take time depending on the drive capacity.
6. To suspend the rebuilding, put the cursor on [Suspend] (when aborting, on the
[Abort]) and press Enter key. When [Confirmation] is displayed, put the cursor on
[OK] and press Enter key. During being suspended, [Suspend] is displayed in
[Progress] of [Physical Drive].
7. When “Rebuild Limit” is set and [Rebuild Range] is set to [Whole], only [Finish]
is can be selected after exceeding the Rebuild Limit. When [Finish] is selected and
“OK” is selected in [Confirmation], the rebuilding is completed at the time. When
OS is booted after exceeding the Rebuild Limit, the rebuild is completed.
J-16 [CONFIDENTIAL]] TECRA S3 Maintenance Manual (960-532)
To Next Page
Loading...
