Toshiba TH650A - Rack Mounting Dimensions; Precautions for Rack Mounting

TRANSPORTATION AND INSTALLATION MANUAL
3.3.3 Rack Mounting Dimensions
When mounting the robot controller in a rack, set the side brackets using the screw
holes provided on both ends of the front panel, and secure the controller to the rack.
The side brackets [1] in Fig. 3.7 are optional.
Fig. 3.7 Screw hole dimensions for securing controller
3.3.4 Precautions for Rack Mounting
Pay attention to the following matters when rack-mounting the robot controller.
a) When mounting the robot controller in a rack, use the screw holes provided on
both ends of the front panel, and secure the controller. (Optional side brackets
are required.)
!
CAUTION
• If the rack is completely sealed, provide holes to allow the air to be let out,
force-ventilate the rack with a fan, or cool it indirectly so that the heat will not
be trapped in the rack.
If the heat is trapped in the rack or controller, faults could occur.
STE 85305
– 29 –