Toshiba TOSVERT VF-nC3 - Page 138

E6581595
F-31
6
[: No voltage compensation/output voltage limited] [: Voltage compensation/output voltage limited]
>
1 the output voltage can be prevented
from exceeding the input voltage.
 
Rated voltage
* The above applies when V/F control mode selection
parameter

is set to "0" or "1".
Output voltage
[
Ｖ
]
Input voltage
Output frequency

High
Low
0
Input voltage

[: No voltage compensation/no output voltage limit] [: Voltage compensation/no output voltage limited]
Input voltage
High
Low
Output
fre
q
uenc
y
Output voltage
[
V
]
 
0
Input voltage
* The above applies when V/F control mode selection
parameter

is set to "

" or "

".
>
1 the output voltage can be prevented
from exceeding the input voltage.
 
Rated voltage

Input voltage
High
Low
Output voltage
[V]
Output frequency

0
* Note that even if the input voltage is set less than

, for a base frequency of

or higher outpu
t
frequency, then an output voltage over

occurs.
Input voltage
High
Lo
w
Output voltage
[V]
Output
frequency
 
0
