Toshiba TOSVERT VF-nC3 User Manual

E6581595
D-12
4
4.4 Checking the region settings selection
 : Checking the region setting
[Parameter setting]
Title Function Adjustment range Default setting

Checking the region setting
0: Start setup menu
1: Japan (read only)
2: North America (read only)
3: Asia (read only)
4: Europe (read only)

* Default setting values vary depending on the setup menu setting. Refer to section 11.5. 1 to 4 are displayed.
 Content of region settings
The number displayed when parameter  is read indicates which of the following regions was selected on
the setup menu.
:  (Japan) is selected on the setup menu.
:  (North America) is selected on the setup menu.
:  (Asia, Oceania) is selected on the setup menu.
:  (Europe) is selected on the setup menu.
The setup menu is started by writing =.
Refer to section 3.1 for details.
Note:  to  set to parameter  are read-only. Be aware that they cannot be written.
 Function
The region selected on the setup menu can be checked.
Also, the setup menu can be started to change to a different region.

Toshiba TOSVERT VF-nC3 Specifications

General

Model	VF-nC3
Category	Inverter
Output Frequency Range	0.1 to 400 Hz
Control Method	V/f control, sensorless vector control
Overload Capacity	150% for 60 seconds
Input Frequency	50/60 Hz
Enclosure Rating	IP20
Input Voltage	200-240V AC
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit
Ambient Temperature	-10°C to +50°C
Communication	Modbus RTU
Cooling Method	Fan Cooled
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +60°C
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m
Braking Unit	Built-in braking transistor (for models up to 22kW), External braking resistor required