E6581595
K-21
11
11.8 Unchangeable parameters in running
For reasons of safety, the following parameters cannot be changed during inverter running.
Change parameters while inverter stops.
［Basic parameters］
(Guidance function) (Maximum frequency)
(Automatic acceleration/deceleration) (V/F control mode selection)
(Torque boost setting macro function) (Default setting)
*(Command mode selection) (Checking the region setting)
*(Frequency setting mode selection)
［Basic parameters］
(Priority selection (Reverse-run prohibition)
(Both F and R are ON)) (Carrier frequency control mode selection)
/ (Always-active function selection
1/2)
(PID control)
Analog/logic input selection (VI terminal) (Auto-tuning)
to (Input terminal selection 1A to 5) (Motor specific coefficient 2)
(Sink/source switching) to (Motor specific coefficient 7 to 9)
to (Output terminal selection 1A～1B) (Emergency stop selection)
(Output terminal logic selection(OUT-NO))
(Output phase failure detection mode selection)
(Factory specific coefficient 1A) (Input phase failure detection mode selection)
to (Input terminal selection 1B~2C) (Detection of output short-circuit during start-up)
(Auto-restart control selection) (Undervoltage trip/alarm selection)
(Regenerative power ride-through control (Factory specific coefficient 6A)
(Deceleration stop)) (Logic output/pulse train output selection
(Overvoltage limit operation (OUT-NO))
(Slowdown stop mode selection)) (Analog output signal selection)
(Supply voltage correction
(limitation of output voltage))
* and can be changed during operation by setting =.
To Next Page
Loading...
