Toshiba TOSVERT VF-nC3 User Manual

E6581595
D-2
4
Status monitor mode The mode for monitoring all inverter status.
Allows monitoring of set frequencies, output current/voltage and terminal
information.
 Refer to chapter 8.
The inverter can be moved through each of the modes by pressing the MODE key.


 
 
y
y
y
y
Setting monitor modeStatus monitor mode
Standard monitor mode
（
At power source on
）
MODE
MODE
MODE
RUN
MON
PRG
PRG
Frequency setting method
 Refer to section 3.2.2
How to search and set
parameters
 Refer to section 4.2
Monitoring of
operation status
 Refer to section 8.2

Toshiba TOSVERT VF-nC3 Specifications

General

Model	VF-nC3
Category	Inverter
Output Frequency Range	0.1 to 400 Hz
Control Method	V/f control, sensorless vector control
Overload Capacity	150% for 60 seconds
Input Frequency	50/60 Hz
Enclosure Rating	IP20
Input Voltage	200-240V AC
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit
Ambient Temperature	-10°C to +50°C
Communication	Modbus RTU
Cooling Method	Fan Cooled
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +60°C
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m
Braking Unit	Built-in braking transistor (for models up to 22kW), External braking resistor required