16502 PIREG-C2 Gerätebeschreibung mit EtherNet_IP Bussystem191017 - EN.docx/ Page 59 of 66
determined by the PIREG-C2 as the mean of all parts of the heating conductor. If any individual parts of
the heating conductor are exposed or otherwise not in contact with any heat dissipating areas, they will
heat up faster than those sections of the heating conductor that are able to dissipate their heat. In this
case, the temperature reached at these sections will be lower than the temperature displayed by the con-
troller and the sealing performance will be worse.
Calibration of the PIREG-C2 is recommended every time a heating conductor is replaced, in order to cor-
rect any tolerances of the heating conductor arising during manufacture. When new heating conductors
are used, burn-in will again be necessary.
To Next Page