Communit
y Name: Enter the Community Name here.
Access: Defines the access rights of the community.
read-only: Management right of the Community is restricted
to read-only, and changes cannot be made to the
corresponding View.
read-write: Management right of the Community is read-write
and changes can be made to the corresponding View.
MIB View: Select the MIB View for the community to access.
Community Table
Select: Select the desired entry to delete the corresponding Community. It
is multi-optional.
Community Name: Displays the Community Name here.
Access: Displays the right of the Community to access the View.
MIB View: Displays the Views which the Community can access.
Operation: Click the Edit button to modify the MIB View and the Access right
of the Community, and then click the Modify button to apply.
Note:
The default MIB View of SNMP Community is viewDefault.
Configuration Procedure:
If SNMPv3 is employed, please take the following steps:
Step Operation Description
1 Enable SNMP function
globally.
Required. On the SNMP→SNMP Config→Global Config page,
enable SNMP function globally.
2 Create SNMP View. Required. On the SNMP→SNMP Config→SNMP View page,
create SNMP View of the management agent. The default View
Name is viewDefault and the default OID is 1.
3 Create SNMP Group. Required. On the SNMP→SNMP Config→SNMP Group page,
create SNMP Group for SNMPv3 and specify SNMP Views with
various access levels for SNMP Group.
4 Create SNMP User. Required. On the SNMP→SNMP Config→SNMP User page,
create SNMP User in the Group and configure the auth/privacy
mode and auth/privacy password for the User.
If SNMPv1 or SNMPv2c is employed, please take the following steps:
Step Operation Description
1 Enable SNMP function
globally.
Required. On the SNMP→SNMP Config→Global Config
page, enable SNMP function globally.
180
To Next Page
Loading...
