NTDP: Displays NTDP
status (enabled or disabled) of the current port.
14.2.3 NTDP Config
On this page you can configure NTDP globally.
Choose the menu Cluster→NTDP→NTDP Config to load the following page.
Figure 14-8 NTDP Config
The following entries are displayed on this screen:
Global Config
NTDP: Select Enable/Disable NTDP for the switch globally.
NTDP Interval Time: Enter the interval to collect topology information. The default is 1
minute.
NTDP Hops: Enter the hop count the switch topology collects. The default is 3
hops.
206
To Next Page
Loading...
