TracVision TV3 User’s Guide
79
Troubleshooting
108 An automated reboot of the TV-Hub is in process to
resolve low memory. No action is required.
109 The TV-Hub is running low on memory but it should be
able to recover without a reboot.
111 The TV-Hub is unable to initialize its built-in wireless
access point (WAP). Contact KVH.
119 The 24 VDC power to the internal SWM module is out of
range. DIRECTV outputs are disabled. Contact KVH.
124 The software update file you selected is not valid for your
antenna model. Try a new update file.
128 The software update failed. Retry updating the software. If
it fails again, check the RF1 cable between the antenna and
the TV-Hub.
129 One of the TV-Hub’s power supplies is out of range.
Contact KVH.
130 The TV-Hub DC input voltage is out of range (should be
10-30 VDC). Check the power source that is supplying DC
power to the TV-Hub.
200 The antenna is not receiving adequate DC power from the
TV-Hub. Check the RF1 cable between the antenna and the
TV-Hub.
203 The antenna’s main board has lost communications with
the azimuth and elevation motors. Contact KVH.
204 The antenna’s main board has lost RF communications.
Contact KVH.
205 The antenna’s azimuth motor has a power failure. Contact
KVH.
206 The antenna’s azimuth motor or limit switch failed.
Contact KVH.
207 The antenna’s elevation motor has a power failure.
Contact KVH.
208 The antenna’s elevation motor or limit switch failed.
Contact KVH.
Error Description
To Next Page
Loading...