Need help?Do you have a question about the Trane Rover and is the answer not in the manual?
Specifies the minimum hardware and software requirements for the Rover service tool.
Details the steps to install the Rover service tool and its components.
Explains how to install and use the communication key for Tracer ZN010 devices.
Explains how to connect Rover to a Tracer SC via the LonTalk interface adapter.
Instructions for verifying network connectivity and diagnostics using USB adapters or PCMCIA cards.
Explains the three operating modes: Passive, Active, and Server-connected.
Instructions for changing controls and parameters for Trane devices.
Details how to save device configurations as Rover Configuration Files (RCFs).
Details on how to bind network variables between devices for data sharing.
Instructions for updating firmware in Tracer LonTalk controllers using the wizard.
Best practices and recommendations for safely performing flash downloads.
To Next Page
General