32 EMTX-SVX01G-EN
Winking a Device
Changing the Device Domain Entry
Use the Domain Entry dialog to view and change the domain addresses for individual devices.
NOTICE
Changing the domain address of a device communicating on the link
will remove any bindings previously created for that device. It will also
cause that device to stop communicating on the link.
When you change the domain entry for a device, a warning appears (see Figure 24) reminding you
to confirm your changes with the network manager.
To change a device domain address:
1. The Domain Entry dialog is available by right clicking on a device in the Active Group tree on
the left and selecting Domain Entry..., or by selecting Device>Domain Entry... from the
main menu.
2. The Domain Entry dialog appears (refer to Figure 25). To disable one or both DSN (A or B),
unselect the Enabled: check box. Both of these check boxes are typically selected.
Communication occurs on DSN (A) and discovery occurs on DSN (B).
Figure 24. Domain Entry Warning
Figure 25. Domain Entry dialog
To Next Page
Loading...