EasyManua.ls Logo

Trane Rover - Device Plug-Ins; Frequently Asked Questions

Trane Rover
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52 EMTX-SVX01G-EN
Device Plug-ins
Device Plug-ins
Before you can use Rover to configure a controller, Rover must have a software module called a
plug-in installed for that controller. In most cases, the plug-in should already be installed with your
copy of Rover.
Each controller and revision of a controller requires its own plug-in. Device plug-ins must comply
with the EIA/CEA-860 standard for software plug-ins.
Rover currently has plug-ins to support the following controllers:
Tracer AH540/541 air-handler controller
Tracer LonTalk Communication Interface, Chillers (LCI-C)
Tracer LonTalk Communication Interface, IntelliPak
(LCI-I)
Tracer LonTalk Communication Interface, ReliaTel
(LCI-R)
Tracer LonTalk Communication Interface, Voyager (LCI-V)
Tracer MP501 setpoint controller
Tracer MP503 input/output (I/O) module
Tracer MP580/581 programmable controllers
Tracer Protocol Interface Controller (PIC)
Tracer VV550/551 VAV controller
Tracer ZN010 zone controller
Tracer ZN510/511 zone controllers
Tracer ZN517 unitary controller
Tracer ZN520/521 zone controllers
Tracer ZN523 zone controller
Tracer ZN524 water-source heat pump controller
Plug-ins are made available for new Trane LonTalk controllers as they are developed. To add a plug-
in or to find out what additional plug-ins are available, contact your local Trane representative or
check the TraneNet information system.
Frequently Asked Questions
What controllers work with Rover LonTalk?
At this time Rover works with the following controllers:
Tracer AH540/541 air-handler controller
Tracer LonTalk Communication Interface, Chillers (LCI-C)
Tracer LonTalk Communication Interface, IntelliPak (LCI-I)
Tracer LonTalk Communication Interface, ReliaTel
(LCI-R)
Tracer LonTalk Communication Interface, Voyager (LCI-V)
Tracer MP501 setpoint controller
Tracer MP503 input/output (I/O) module
Tracer MP580/581 programmable controllers
Tracer Protocol Interface Controller (PIC)
Tracer VV550/551 VAV controllers

Table of Contents