EMTX-SVX01G-EN 51
Other Rover Software Tools
Files and Software Required for Flash Downloads
To perform a flash download, you will need:
• The image file or files for the selected controller
• The software plug-in compatible with the image file you want to download to the selected
controller
Trane will distribute image files and new plug-ins as needed to support upgrades to controller
firmware.
Guidelines for Performing Flash Downloads
Follow these guidelines for flash downloads:
• Perform a flash download only when directed to do so by a technical support representative or
a Trane service bulletin.
• Before performing a flash download, use the operator interface to shut down the controlled
equipment. Controllers cannot maintain control of equipment during a flash download.
• Typically, only perform flash downloads on links managed by Trane. For flash downloads on
third-party links, use the third-party tool whenever possible or remove the controller from the
link, then perform the flash download with the Flash Download Wizard. Set the discovery
domain to the domain where the devices are currently installed using the Settings button in the
Flash Download Wizard. The third-party network manager must then re-install the device.
• Before you begin, save your controller configuration data to configuration files (RCFs). If your
controllers have bindings, record the list of bindings for each controller.
• Read the flash download FAQ in the online Help before doing a flash download (Press F1 or click
the Help button in the wizard).
Note: You cannot perform a flash download remotely through Tracer Summit.
Figure 40. Flash Download Wizard main screen
To Next Page
Loading...