50 EMTX-SVX01G-EN
Other Rover Software Tools
For more information on air and water balancing, refer to the Air and Water Balancing user guide
in the Rover folder on your hard disk.
Flash Download Wizard
Use the Flash Download Wizard (Figure 40, p. 51) to update the firmware in Tracer LonTalk
controllers that have flash memory. You can flash download a single controller or groups of
controllers of the same type. Depending on the changes to the firmware, the Flash Download
Wizard usually restores controller configuration data after a flash download but cannot restore
bindings.
Rover 7.0 Flash Download Wizard now allows you to change the network settings used while
performing this task. This means you can use this tool on non-Trane domains. To change the
network settings while using the Flash Download Wizard:
1. Cli ck Settings (Figure 40, p. 51) if the installed link is on a non-Trane domain. If devices are
installed on a Tracker loop controller or Tracer Summit BCU, skip steps 1-4 and click Next.
2. The Network Settings dialog appears (refer to Figure 39).
3. Set the Domain Length and Domain ID (hex) as described in “Defining the Discovery DSN,”
p. 45
4. Click OK.
Figure 39. Network Settings
To Next Page
Loading...