10 EMTX-SVX01G-EN
Connecting to LonTalk Links
Connecting to LonTalk Links
This chapter shows how to connect Rover to a LonTalk device or network.
Connecting a Communication Key
Most Tracer controllers have built-in communications capability, but the Tracer ZN010 does not. To
connect to a Tracer ZN010, you must first install the communication key (Figure 1). Two
communication keys are included with the Rover LonTalk hardware package.
NOTICE
Avoid Communication Key Damage
You must power down the Tracer ZN010 to install or remove the communication key. Failure to
do so may damage the communication key.
Figure 1. Connecting the communication key to the controller
To Next Page
Loading...