Threat Protection System Hardware Specification and Installation Guide 13
◦ Red: Indicates that the system is experiencing a health alert, such as a fan failure. This state resets to
solid green when you view the system log.
• Management port status
◦ Link LED: Solid green indicates that the port is linked and ready for data.
◦ Activity LED: Flashing amber indicates that the port is passing data.
• Power button status
◦ Off: Indicates that the system is off.
◦ Solid green: Indicates that the system is on.
Model requirements
The following topics describe specific requirements for the TPS TX Series devices.
• Power requirements on page 13
• Cabling requirements on page 25
Power requirements
The 8200TX and 8400TX devices require Alternating Current (AC) or Direct Current (DC) that meets the
following requirements:
• AC: Voltage 100V to 240V; 12 to 6A; 47 to 63 Hz
• DC: Voltage -40V to -60V; 24 to 16A
The TX Series devices ship with two AC power supplies. DC power supplies are also available for the
device. Consult your TippingPoint account contact for more information if you require a DC power supply.
Cabling requirements
The TPS 8200TX and 8400TX devices ship with the following cables:
• Two AC power cables, one for each hot-swappable power supply
• Null modem cable (USB to RJ-45) for the serial console management port shown in Figure 6 on page
11
I/O module installation
Use these instructions to set up the I/O modules supported in TippingPoint security devices.
This section includes the following topics:
To Next Page
Loading...
