Threat Protection System Hardware Specification and Installation Guide 51
Important: After you insert a new card into the CFast slot, be sure to mount the user disk. Failure to
mount the user disk prevents the device from automatically mounting the disk when the device
is rebooted.
External user disk commands
Lists the commands used to manage the external user disk (CFast or SSD) in the CLI.
Refer to the TPS CLI Reference for detailed documentation of these commands.
Table 17. External user disk CLI commands
Command Description
user-disk format Formats the external user disk. Any existing data on the external
user disk will be erased.
user-disk mount Manually mounts the external user disk.
Important: If you replace the external user disk while the device
is turned off, be sure to also restore power to the
device so that you can mount the replacement disk.
Failure to mount the replacement disk prevents the
device from automatically mounting the disk when
the device is rebooted.
user-disk unmount Unmounts the external user disk so that the user can remove it.
user-disk encryption
enable
Encrypts the external user disk if the system master key has been
set. Changing the encryption status reformats the external user
disk and erases all data on the drive.
Note: Master key and encryption controls can also be configured
using System > Settings > Data Security in the LSM.
For more information, refer to the Local Security Manager
User Guide.
To Next Page
Loading...
