28 Threat Protection System Hardware Specification and Installation Guide
TPS 440T product overview
This information describes the components, chassis, requirements, and installation specifics of the TPS
440T device. The following topics are discussed:
• Device overview on page 28
• Model requirements on page 32
• Technical specifications on page 32
For information about installing the device, see Install your TPS device on page 34. Prior to installation,
have the TPS CLI Reference available for configuration information.
Device overview
The 440T device is a small form-factor device designed for smaller network environments requiring up to 1
Gbps of inspection throughput. This model provides the same high-level security protection as the higher-
capacity models.
Chassis – front panel
The TPS 440T device is a 1U form-factor device that is rack-mountable in a 19-inch rack (or 23-inch rack,
with appropriate conversion parts available from rack accessory vendors).
The following image is a front panel view of a TPS 440T device:
Figure 10. TPS 440T device – front panel
1. CFast card
2. 1GB copper ports
3. Dedicated HA port
4. Serial console port/Management port
To Next Page
Loading...
