34 Threat Protection System Hardware Specification and Installation Guide
Install your TPS device
After you have completed preparation procedures and unpacked the TPS device, you are ready to install and
configure the components. Have the TPS CLI Reference available for configuration information reference.
After installation of the hardware components, complete the initial setup wizard as part of the installation
and configuration procedures.
Note: Before installing your device, review and adhere to all safety guidelines described the TPS Hardware
Safety and Compliance Guide, which also contains detailed regulatory compliance information and is
included with your product shipment.
This information includes the following procedures:
• Install the chassis on page 34
• Connect the power supply on page 35
• Attach the cables on page 36
• Check the LEDs on page 37
• Run the setup wizard on page 38
Install the chassis
This information provides general guideline information for all TippingPoint devices. For installation
guidelines specific to your TPS device, refer to the appropriate Install your security device quick start for your
model available on the TMC at https://tmc.tippingpoint.com.
Before installing your new security device, gather any necessary materials and prepare the network and
hardware site. To carefully and correctly install the device, read through all preparation instructions and
requirements. This information provides general guideline information for all TippingPoint devices.
To install the device you must do the following:
• Determine total rack space on page 34
• Attach the device to the rack on page 35
• Connect the power supply on page 35
Determine total rack space
Before you install the chassis, determine the total rack space that is required to install your system. The total
required rack space increases if you plan to install multiple systems.
To Next Page
Loading...
