TRENDnet TEG-448WS - System Configuration

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-448WS
7
Configure your switch
Access your switch management page
Note: Your switch default management IP address http://192.168.10.200 is accessed
through the use of your Internet web browser (e.g. Internet Explorer®, Firefox®,
Chrome™, Safari®, Opera™) and will be referenced frequently in this User’s Guide.
1. Open your web browser and go to the IP address http://192.168.10.200
. Your switch
will prompt you for a user name and password.
2. Enter the user name and password. By default:
User Name: admin
Password: admin
Note: User Name and Password are case sensitive.
System Info
View your switch status information
System Info
You may want to check the general system information of your switch such as firmware
version, boot loader information and system uptime. Other information includes H/W
version, RAM/Flash size, administration information, IPv4 and IPv6 information.
1. Log into your switch management page (see “Access your switch management page
”
on page 7).
2. Click on System Info.
System Information
• System Up For – The duration your switch has been running continuously without
a restart/power cycle (hard or soft reboot) or reset.
• Runtime Image: The current software or firmware version your switch is running.
• Boot Loader – The current boot loader version your switch is running.
Hardware Information
• Version: Displays your switch hardware version.
• DRAM Size: Displays your switch RAM memory size.
• Flash Size: Displays your switch Flash memory size.