TRENDnet TEG-448WS - Static Multicast; Add Static Multicast Entries to the Switch

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-448WS
31
Static Multicast
Add static multicast entries to the switch
Bridge > Static Multicast
In this section, you can add static multicast entries to the switch configuration.
1. Log into your switch management page (see “Access your switch management page
”
on page 7).
2. Click on Bridge and click on Static Multicast.
3. Review the settings.
• 802.1Q VLAN – Enter the VLAN ID where the multicast group MAC address will
reside.
Note: By default, all switch ports are part of the default VLAN, VLAN ID 1.
• MAC Address – Enter the multicast group MAC address.
• Group Member – Check the port(s) where the MAC address will reside.
Note: You can click All to select all ports.
Click Apply to add the Static Multicast Group entry to the list.
In the list, you can click Modify to modify an entry or click Delete or delete the entry. If
the entries span multiple pages, you can navigate page number in the Page field and
click Go or you can click First, Previous, Next, and Last Page to navigate the pages.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.