TRENDnet TEG-448WS - View Your Trunk Group Status Information; Configure Your Port Priority

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-448WS
27
View your trunk group status information
Bridge > Trunk Config > LACP Group Status
1. Log into your switch management page (see “Access your switch management page
”
on page 7).
2. Click on Bridge, click on Trunk Config, and click on LACP Group Status.
3. View your trunk group status information.
• System Priority - Preassigned setting that cannot be modified. This value
applies to the switch.
• System ID - MAC address value assigned to the individual switch. This value
cannot be modified.
• Group: # The ID number of the trunk (link aggregation group).
Configure your port priority
Bridge > Trunk Config > Port Priority
1. Log into your switch management page (see “Access your switch management page
”
on page 7).
2. Click on Bridge, click on Trunk Config, and click on Port Priority.
3. Review the settings. Click Apply to save changes.
To assign a port higher priority within a trunk group, find the port number and in the
priority column, enter a priority value 0-65535 (65535 being the highest priority).
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.