TRENDnet TEG-448WS - Static Unicast; Add Static Unicast Entries to the Switch

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-448WS
30
Static Unicast
Add static unicast entries to the switch
Bridge > Static Unicast
In this section, you can add static unicast entries to the switch configuration.
1. Log into your switch management page (see “Access your switch management page
”
on page 7).
2. Click on Bridge and click on Static Unicast.
3. Review the settings.
• 802.1Q VLAN – Enter the VLAN ID where the MAC address will reside.
Note: By default, all switch ports are part of the default VLAN, VLAN ID 1.
• MAC Address – Enter the MAC address of the device to add.
• Port Member – Select the port where the MAC address will reside.
Click Apply to add the Static Unicast entry to the list.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all the entries in the list. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.