Confirm Connectivity
1. Leave your computer connected to TEW-740APBO #2 and keep the access point
management page open.
2. Make sure both TEW-740APBO #1 and TEW-740APBO #2 access point are powered on
and approximately 15 ft. (5 m) apart from one another with the front of access points
directly facing each other.
3. To verify connectivity, in the TEW-740APBO #2 access point management page, click
on Utility and click on Network Utility.
4. In the IP/Domain field, enter the IP address 192.168.10.50. Next to Times, click Ping.
Ping replies and 0% packet loss will indicate a successful WDS point to point bridge has
been established between the two access points as shown below.
You can also check under Wireless and WDS Status the status of the wireless point to
point bridge between the two access points.
Note: If the connectivity test fails, wait for about 1 minute and try again. Make sure
there are no obstacles between two access points and that they are not too close
together.
To Next Page
Loading...
Need help?
General
