Primary Product Application
The intended purpose and application for this product is to extend network connectivity
across long physical distances outside of an area or building that lacks local connectivity
using point-to-point wireless bridge capability using 802.11 standards. Essentially, two
access points configured in point-to-point bridge capability can connect/link the two
physical locations or buildings together through an encryption wireless connection.
Although this product supports multiple wireless modes, the basic installation will only
cover the primary application of point to point wireless connectivity in WDS (Wireless
Distribution System) Bridge Mode using AES encryption for security.
Minimum Installation Requirements
Computer with RJ-45 Ethernet port and web browser
4 x RJ-45 Ethernet cables (not included)
Phillips screwdriver (not included, for grounding wire installation only)
Additional TRENDnet TEW-740APBO H/W: v2.XR N300 directional wireless
access point (For TEW-740APBO single unit only, TEW-740APBO2K model
includes two preconfigured access points)
For wall mounting only (included wall mounting kit for drywall installations only)
Power drill/driver
7/16 in (2.75 mm) straight drill bit for hard wood or 3/32 in (2.35 mm) bit for
soft wood (for mounting screws)
11/16 in (4.3 mm) straight drill bit for hard wood or 5/32 in (4 mm) bit for soft
wood (if required for drywall anchors)
Philips driver bit or screwdriver
To Next Page
Loading...
Need help?
General
