RADIUS Setup – Enable or disable RADIUS authentication. This will authenticate users
through the external RADIUS authentication server and require that you have already a
server set up manually.
Primary Server IP – Enter the IP address of the primary RADIUS.
Secondary Server IP – If you have a secondary or backup RADIUS server, enter
the IP address.
Authentication Port – Enter the authentication port number used by your
RADIUS server for authentication requests. Typically, the default RADIUS server
port is 1812.
Accounting Service – If your RADIUS server also has accounting enabled, check
the option and enter the accounting port. Typically, the default RADIUS server
account port is 1813.
Authentication – Select the authentication type used by your RADIUS server for
user authentication. Typically, CHAP is used since it is more secure than PAP.
Secret Key – Enter the shared secret required by your RADIUS server.
If you have bandwidth restriction limits for your guest users, you can specify those limits
per user and total allocated bandwidth in Kbps.
Guest Authentication
System > Authentication > VLAN # > Guest
This section allows you configure the guest authentication function.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click System, click on Authentication, and in the first entry VLAN 0, in the Action
column, and click on drop-down list and click Guest. Review the settings and click
Save to apply the changes.
To Next Page
Loading...
Need help?
General
