© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-750DAP
34
5. If your wireless network requires wireless security, you will be prompted to enter
your wireless key. Enter your Wireless Key required to connect to your existing wireless
network and click Next.
Note: If you wireless network does not require wireless security, skip to the next step.
6. Click Save Settings to apply the changes.
7. Wait for the device to apply the settings.
8. To verify the access point has successfully copied the settings and repeated the signal
of your wireless network, wait for the Link Status to display Connected.
It may take up to 1 minute for your device to verify and display the connection status.
Note: If the Link Status does not display a Connected status after 1 min, please re-
attempt the procedure.
Status > Link Status
• Status – Displays the connection status of the device either Connected or
Disconnected.
• Tx Link Speed – Displays the estimated wireless transmission speed established
to the wireless network.
• Rx Link Speed – Displays the estimated wireless receive speed established to
the wireless network.
• Signal Strength – Displays the estimated signal strength of the wireless
network detected by the device.
9. Once your wireless signal has been successfully verified, unplug the device and plug
into an available power outlet in the area you would like to repeat or extend signal
coverage of your existing wireless network.
Note: You can also connect additional wired network devices to the available LAN ports
1-4 on the back of the device via Ethernet to connect these devices to your network.
To Next Page
Loading...
Need help?
Operating Environment
Power
Weight and Dimensions
