Below is a reference of the additional Dynamic DNS settings if you choose to make other
configuration changes to these sections.
Timer Settings
Allows you to configure a specified interval to force your router to send a DDNS update
to your DDNS service provider.
Note: Please note that it is recommended not to set the interval too low and send
updates too often as this may not meet the minimum requirements of your DDNS service
provider client update policy.
• Force Interval – Enter a value in days, hours, or minutes.
Note: The smallest interval allowed is 10 minutes. Setting the value to 0 will
force your router to send a DDNS update only once and will not resend any
more DDNS updates for the specified WAN.
Log File Viewer
Allows you to view the log status for Dynamic DNS of your router.
• Refresh – Clears any logged displayed and reload new logs
File sharing server
System > Samba (USB)
Your router’s USB port can be used to share files through the network when a USB
storage device is connected on the back USB port. The router supports Samba (SMB) file
sharing protocol and is compatible with SMB/CIFS.
Note: Only FAT32 or NTFS file formats are supported, up to 4TB max. storage size.
After you have connected your USB storage device:
1. Log into your router management page (see “Access your router management page”
on page 6).
2. Click on System and click on Samba (USB).
3. Review the settings below. When complete, click Apply to save and commit your
changes.
Note: By default, the Samba server name is set to TEW-829DRU or the LAN IP address
may also be used default LAN IP: 192.168.10.1. To change the Samba server name, you
can modify this setting under Administrator > System and edit the Host Name setting.
Samba General Settings
• Enable – Check the enable option to enable Samba file sharing.
• Description: Enter a description for the server.
• Workgroup: Enter the workgroup name. It is recommended to keep the standard
default “WORKGROUP”. If you change this setting, you will need to change the
workgroup name on all computers in your network that are allowed access to the
USB storage in order to discover it automatically. Otherwise, you will need to
access the server by IP address.
• Login Required – Selecting No will not require computers to login when accessing
the USB share. Select Yes will require computers to enter a user name and
password when accessing the USB share and user account can be modified under
the Samba Users list. This user account will have full read/write permissions on
the USB share.
To Next Page
Loading...
