2 Unit Setup
removal. The table below shows which screen protectors can and cannot be used on the glass-PET
screen and the new glass-glass screen:
Screen protector Film-
Glass
Glass-
Glass
Old ACCAA-362 Ranger 3/TSC3 screen protectors (pkg of 15) YES NO
New ACCAA-371 Anti-Glare Screen Protector, 4.3" Glass-Glass
Touch Panel
NO YES
Charge the battery
Note – Fully charge the battery at least 4 hours after installing in the unit. The battery LED (left LED) will turn
green when fully charged
The power supply that ships with your unit has four international plugs that fit almost every
electrical outlet in the world.
1. Connect the appropriate plug to the power cord and attach to the power supply.
2. Plug into an electrical outlet and plug the barrel end of the power supply into the unit.
WARNING – Make sure to only use the power supply included with your unit. Use of other adapters may void the
product warranty.
Turning your unit on and off (resume/suspend)
The unit should boot up when the battery is installed. If not, press and release the green Power key
on the keypad.
To turn your unit off, press and release the Power key again.
One of the most convenient features of your unit is “suspend/resume”. There is no waiting for the
unit to boot up every time it is turned on.
Note – This feature does not occur on the first boot-up.
Ranger Series Handheld Computer 26
To Next Page
Loading...
Need help?
General
