PT - 262
6 OPERATIONS MODE SELECTION
The ECR has 6 operation modes. Press key [CLERK] to shift operation mode. These 6 modes can be shifted in turn.
See the corresponding chapter for functions of each mode.
REG Sales operation mode
X REPORT To read various reports
Z REPORT To read reports and reset the total to zero
SET To set some items
SYSTEM SET To set system parameter
OFF ECR Soft off power
AC The cursor flashes when AC is lost
Before performing any sales operations, a clerk must login. Read the chapter 7 ‗LOGIN AND LOGOUT SYSTEM‘
for a description of clerk operations.
All report can be printed in X or Z mode. The difference between them is:
In X mode, total sales sum is not set to zero after printing report, next sales sum will be accumulated.
In Z mode, total sales sum is set to zero after printing report, next sales sum will be recalculated.
Attention: If transaction has been done in REG mode, you must print Z daily report (refer to chapter 11.3 for Z
daily report printing) before entering SET mode and SYSTEM SET mode.
Flicker when pressing
[SHIFT] key.
Flash when the receipt
paper runs out.
Flash when in
RETURN mode.
To Next Page
Loading...