Doc No. FM0816 issue 4 Page 10
You can call a resident any time by dialling their room number on the DECT handset. To call any other intercoms in the
common room, corridors, etc. use the same procedure but enter the actual intercom number.
1. Press the LINE key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the room number of the resident you wish to contact
4. Press the key to send a call tone and open speech
Press the 0 key to re-sound the call tone if required
5. Speak to the resident, stop speaking to listen
6. Press the # key to end the call
7. Press the LINE key to clear the connection
10. SEQUENTIAL DAILY CALLS
Routine daily sequential calls to all residents can be greatly simplified by using the INDEX function.
You can start sequential calls from any room number.
1. Call and speak to the first resident in the normal way
2. Press the 6 key to end the call
3. A message will announce the next room number
4. Press the key to speak or the 6 key to skip
Press the 0 key to re-sound the call tone if required
5. Repeat as above through all room numbers
6. Press the # key to end sequential calls
7. Press the LINE key to clear the connection
If you hear a short “beep” every 5 seconds in the telephone earpiece this means there is another call waiting.
1. On hearing the intermittent beep conclude your conversation as quickly as possible
2. Press the # key once to end the call
3. A message will announce the call waiting
4. Press the key to answer the call in the normal way
or press the # key a second time to check if more than one call is waiting
5. The message will change with each press of the # key for all calls waiting
6. The calls waiting can be answered in any order by pressing the key after the message
7. When all calls have been answered press the # key followed by LINE key to clear the connection
To Next Page
Loading...
