The telephone will ring when a call exists. If there are multiple handsets the first person to answer will get the call, all
other phones will stop ringing. An alarm message in the earpiece will announce the call type.
1. When the handset rings press the LINE key
2. Listen to the alarm message in the earpiece
3. Press the key after the message to open speech
4. Speak to the resident, stop speaking to listen
5. Press the # key to end the call
6. Press the LINE key to clear the connection
NORMAL CALL TYPES
An alarm call initiated by a resident will normally be from the intercom unit, a ceiling pullcord or a personal pendant.
The following messages will be heard;
“intercom alarm flat 1” if the call was made from the intercom unit in flat 1
“pullcord alarm flat 1” if the call was made from a ceiling pullcord in flat 1
“pendant alarm flat 1” if the call was made from a pendant allocated to flat 1
AUTOMATIC CALL TYPES
An alarm call triggered automatically may be from a smoke detector, a PIR movement detector or another
environmental device. The Advent XT2 monitors itself for faults and these are also reported, see examples below;
“smoke alarm flat 1” the smoke alarm has detected a fire in flat 1
“intruder alarm flat 1” the PIR has detected an intruder in flat 1
“fault alarm flat 1” there’s a fault with the intercom in flat 1
“open circuit alarm flat 1” there’s a wiring fault on a ceiling pullcord in flat 1
“system mains fail” the system mains supply has failed
“system battery low” the system battery standby is running low
“system mains restored” the mains supply is restored
“system BT line fault” there’s a fault with the telephone line
“system BT line restored” telephone line is restored
“system fuse blown” the system has blown a fuse
The faults can be listed by entering a special code via the DECT handset - see section 16 of this manual.
To Next Page
Loading...
